|
|
Vapir Air One 5.0 Vaporizer Instruction Video
Vapir Air One 5.0 Vaporizer Instructions
Step by step instructions on using the Vapir Air One 5.0 Vaporizer.
Due To High Air Pressure, Temperatures May Fluctuate Several Degrees Causing The Green Light To Flicker Between Red And Green. This Is Normal.
It is imperative that you place your Vaporizer´s fan setting on the HIGH or H position when starting it up.
Failure to do this may cause damage to your Vaporizer that is not covered under warranty.
This vaporizer has 3 Fan speed settings: Low, Medium & High.
The unit should always be started on H for HIGH so that it can properly achieve the speed it requires. The unit might not operate properly if it is not started on the HIGH position.
If the unit is heated without the fan on, it could possibly overheat and cause damage to the unit that is not covered by the warranty In the event that this occurs, immediately turn it off and restart on HIGH.
If your fan ever turns off or you notice it is not on, immediately turn the unit to the off position, adjust the fan speed to H (HIGH position), and turn the unit on with the heat off (heat is the large button with a flame on it). Do this for 5 minutes. It should cool your device for usage.
Never unplug or turn your unit off until it has had sufficient time to cool down. Always leave the fan running without heat for a minimum of 5 minutes after each use.
As a safety precaution, your unit is equipped with an internal safety switch. This switch will disable your unit should it ever overheat. If your unit malfunctions or stops heating, leave the fan on H (High position) for 20 minutes to cool the unit down.
Then, turn your unit off. At this time, it is safe to either restart the unit or unplug it and store. Always unplug the unit from the electrical outlet before cleaning.
Always make sure your unit is completely dry before turning it on.
Do not attempt any repairs to your unit as doing so may cause fatal injury or void your warranty.
Vapir Air One 5.0 Vaporizer Information
|
|
|
