|
|
VaporTower Vaporizer Instruction Video
VaporTower Vaporizer Instructions
Step by step instructions on using the VaporTower Vaporizer.
Turn the heat control knob on the VaporTower Vaporizer to around 10:00-10:30 and let the VaporTower warm up for about 5 minutes.
DO NOT attempt to use the VaporTower at higher temps without previous experience! The heater is VERY powerful and easily capable of BURNING your material and lungs if turned up much higher!!!
Grind or cut up material. Unscrew VaporTower Glass Handkit, load material into the short side of the metal fitting of small "bowl" end.
Recommended load is anywhere from just covering the screen to filling metal chamber. Do not over fill.
Carefully Screw handkit back together to avoid spilling material.
If loaded fully, you do not need to screw it together completely and tightly. If loaded lightly, screw together completely.
Insert handkit into VaporTower. Begin by taking a fast and short puff through the tubing.
This is to prevent burning if the heat setting is too high. For each consecutive puff, slow down your breath.
The slower you inhale, the hotter and stronger the resulting puff will be. Experiment until you find your ideal breath and temp range preference on the knob. You will quickly get a feel for this.
CAREFULLY remove handkit after a few puffs. The glass and metal parts may be very HOT to touch, so please proceed with caution. Once metal is cool enough to handle, unscrew handkit to look at material.
If the material blackened, you should turn the knob down a little or draw faster. If you do not get a puff, you should turn the temperature up a little and/or draw slower.
At first it may not feel like you are getting a puff because Vapor is a cool clear oil mist that dissipates quickly and is not seen unless you blow against a light source.
Some people prefer a higher setting for a more full-bodied, slightly smoky puff. After a few puffs you will notice your exhaust thinly decreasing, indicating that the material is depleted of its essential oils.
Once Material is "spent" and handkit has cooled to the touch, unscrew and expel material turning the top bowl upside down.
Use stir tool to help remove any stuck material from both sides of handkit. Be carefulnot to lose the Silicone rubber O-ring or screen.
VaporTower Vaporizer Information
|
|
|
